www.BISSELL.com
18
Replacing Belts & Brush Rolls
Brush Roll & Nozzle Care (Continued)
What you will need: 1 Phillips screwdriver & 1 flathead screwdriver
Use a flathead
screwdriver and
press it into the slot
at the back
and
then front
of the
belt access door.
Lift to remove the
Belt Access Door.
While the machine is upright, unplug the machine and remove both tanks. Remove
the nozzle and brush chamber cover (see steps in Brush Roll & Nozzle Care). Press
the recline pedal and lay the machine on its back.
When finished, return the brush roll cover by
pushing it straight down. You will here a click from
each “push” button when the cover is pushed
down into place. Line up the nozzle from the edge
near the floor and rotate to snap back into place.
Turn the machine on its side and use
a Philips screwdriver to remove the
screw just underneath the wheel. Slide
the wheel down to remove.
Use the comb to brush out the
debris or hair from the brush rolls.
Lay the machine
back down on
its back. Use a
Phillips-head
screwdriver to
remove the screw
on the brushroll
end cap.
click
If the Gear Belt
is broken, gently
remove it. If you
are replacing your
brush rolls, gently
remove the belt.
5
6
1
2
3
4
5
