Cleaning the filter and screen
1.
Turn hand vacuum OFF.
2.
Unplug hand vacuum from electrical outlet.
3.
Disconnect dirt container and filter assembly
from the unit.
4.
Remove filter by grasping tabs on both sides
of filter frame and pulling away from the dirt
container.
5.
Separate filter assembly by grasping tabs on
both sides of assembly and pull. For best results,
periodically tap filter and screen against trash
can to remove dirt that has collected.
6.
Reconnect filter and screen by aligning
rectangular tab on filter with insert on screen.
Press together to ensure assembly is secure.
7.
See page 5 to reattach dirt container.
NOTE: Dirt container and screen may be rinsed
with cold water. Ensure both are dry before
reinserting. Do not rinse pleated filter.
Storage/Cord wrap system
1.
To store the unit, turn hand vacuum OFF.
2.
Unplug hand vacuum from electrical outlet.
3.
Bundle cord, using wrap that is located on
cord, to store.
Nozzle Maintenance
Keep nozzles clean and free of debris.
1.
Wipe nozzles clean with damp cloth.
www.BISSELL.com
6
Maintenance & Care
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
5.
5a.
6.
Insert
Tab
4.
Troubleshooting
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Problem
Possible causes
Remedies
Hand vacuum
won’t turn on
Power cord not plugged in.
Check electrical plug.
Blown fuse/tripped breaker in home. Check/replace fuse or reset breaker.
Thermal protector is activated.
Turn OFF and unplug the unit. Empty
dirt container, clean filter and screen,
and clear any clogs. Wait 30 minutes
before turning the unit back ON.
Hand vacuum
won’t pick
up or has
low suction
Dirt container not installed
properly.
Check assembly of dirt container
making sure it is snapped in.
Dirt container is full.
Empty dirt container and reattach.
Filter or screen is dirty.
See instructions above. Replace filter
if needed.
Nozzles are clogged with debris.
Wipe tools clean with damp cloth
