w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
O
perations
6
transporting your cleaner
use the handle on the front to carry
the cleaner or place the cleaner in the
upright position and tip back to roll on
the rear wheels.
Releasing the power cord
the upper and lower cord wraps rotate
to allow for quick and easy removal of
the power cord.
fingertip power switch
the power button is located at the top
of the vacuum handle.
to turn cleaner on, press button once.
to turn cleaner off, press button again.
note: the rotating brush will not turn
on unless the unit is in the reclined
position and the brush switch is on.
handle positions
use your foot to pull the handle release
pedal back to recline the vacuum cleaner.
height adjustment
there are seven height settings available for
various floor surfaces. turn the dial on the
foot of the cleaner to the desired setting.
lowest setting – for low pile carpet or
bare floors. to pick up debris it may be
necessary to move up one setting.
Medium settings – for medium pile carpet.
high setting – for high pile and most
shag/frieze carpet.
note: for optimal carpet cleaning
performance, adjust to the lowest
practical setting. if your cleaner is
difficult to push, adjust to the next
higher setting.
caution: for frieze style carpets,
it is recommended that the rotat-
ing brush be switched off when
vacuuming. please check with your
carpet manufacturer for additional
cleaning tips.
if the dial is difficult to turn, tilt the
cleaner back slightly to take the weight
off the foot while turning.
attention
:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area may aggravate this
condition. Consider setting
your cleaner on a higher than
normal setting for this type of
carpet.
