w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
tool required: phillips screwdriver
1.
Slide upper handle into lower handle by
pushing forward. Insert two long screws
into the holes marked with arrows and
tighten both until snug.
2A.
Attach hose rack by placing the rack
over the center back portion of the
vacuum. Be sure to feed the power cord
through the opening in the center of the
rack.
2B.
Line up both screws holes and use the
two smaller screws to attach. Tighten
both until snug.
3.
Attach hose by placing the tabbed end
into the lower left opening on corded
side of the vacuum. Make sure the tab
on the hose cuff and the hole in the
vacuum line up. Place the working end
of the hose into the hole on the side with
the extension wand guides.
Arrange the
hose so it lays between the vacuum and
the rack.
4.
Store the TurboBrush on the front of the
handle by aligning the slot on the bottom
with the tab on the handle. Snap into
place.
5.
Store the Combination Brush in the slot
shown.
6.
Make sure the crevice tool is inside the
extension wand. Store tools on vacuum as
shown.
1.
2a.
5
caution:
Do not plug in your vacuum
cleaner until you are familiar
with all instructions and
operating procedures.
2b.
4.
6.
5.
3.
