9
www.BISSELL.com
Maintain the TurboBrush® Tool
Twist gray collar
counter-clockwise,
until slot appears,
then separate
faceplate.
1
2
3
Remove Brush Roll,
Belt and Paddle
Wheel. Inspect
for damages and
replace if necessary.
To reassemble, align two clips on each
end of Paddle Wheel with Belt on
and pop back into place. Place Brush
Roll with belt back in. Faceplate will
not close properly if all parts are not
aligned correctly.
Unplug vacuum, turn over and unscrew
six (6) Phillips-head screws to remove
the bottom cover. Lift brush straight out.
Clean debris from Brush
Roll. Inspect by placing
on its end and spin. The
Brush Roll should spin
freely, multiple times by
one flick. If it doesn’t,
replace Brush Roll.
Check Belt for wear
or cuts and replace if
necessary.
Replace the Brush Roll and Belt
by looping the belt over the motor
shaft and the Brush Roll. Line up
the end caps and pull the brush
forward into place. This will stretch
the Belt. Return bottom cover
back on and replace the screws.
End Cap
Belt
Replace Brush & Belt
1
2
3
WARNING
To reduce the risk of electric shock, turn power switch OFF and discon-
nect plug from electrical outlet before performing maintenance or troubleshooting checks.
