
PERIODIC MAINTENANCE OF FLEXIBLE SHAFT AND POKERS
1.-To do the maintenance works in the transmission and poker, firstly disconnect of the motor. 2.-In all
maintenance operations, original parts will be used.
3.-To check the wear of the poker controlling the outside diameter and length of the poker. Replace the
housing or cap when the diameter or length in the least point is less than the specified in the table according
to the model.
4.-Lubricate the shaft every 100 working hours.
A way to lubricate the shaft is to grasp some grease in the palm of the hand and run the close hand with the
lubricant over the length of the shaft, leaving on the shaft a light coating of the lubricant on the entire length
of the shaft, The recommended quantity is 25 g per meter. Do not over lubricate, it could cause the grease
penetrate into the poker; Do not clean the shaft with solvent. The grease recommended is STABURAGS N-4
of the brand KLUBER LUBRICATION, or other equivalent with the following characteristics:
Dropping point s/ DIN 51801/1(ºC)
Temperature range (ºC)
Maximum temperature during a short time(ºC)
Worked penetration s/ DIN 51804 (0.1mm)
Consistence s/ DIN 51818
Speed factor (ndm)
>220
30-130
180
260
2/3
500.000
5.- When the length of the shaft is not equal to the hose (+-10 mm) it is necessary to repair before producing
a bigger breakdown.
6.- Every 300 hours of working is recommended to change the lubricant of the poker.
6.1 STORAGE
When the AVMU motor has not been used for long periods of time, it should always be stored in clean, dry,
and protected areas.
6.2 TRANSPORTATION
When transporting by vehicles, ensure the AVMU motor is safe against slipping, overturning and blows.
.
ELECTRICAL DIAGRAMS
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
Italia Star Com Due S.R.L.
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
45