Bison HHBD01SK-01, Руководство пользователя

Страница: 14 / 38

14
12. Plug in and fasten the trolley plugs into the hoist.
13. The hoist is now ready to test. Connect the power cord to the mains.
14. Once the emergency stop has been released and the start/ on button has
been pressed you should instantly hear a click in the hoist as the main
contactor comes in. You can now test the hoist and trolley directions. Before
proceeding to operate the hoist, check that the hoist directions are correct,
that the emergency stop button works and that the limit switches work.
15. If you have wired your hoist to the power supply and are not getting any
power to the hoist you might have reversed 2 of the phases. This can be
checked by opening the front cover of the hoist. There you will find a small
white relay with led lights on it. If the fault light is on you must swop any 2 of
the 3 power cables. (Refer to page X)
16.
If your trolley’s directions are not correct, wiring changes in the trolley will
need to made.
TROLLEY DIRECTION CHANGE
If after having wired the trolley in and you find that directions are wrong this can easily
be rectified by following these steps.
Single speed: If when you push the cross travel direction the hoist/trolley moves in a
particular direction and you want it to move in the opposite direction when you push the
same button open up the trolley motor and swop positions of 2 of the wires of the cable
you previously installed such as u1 with v1, this is known as phase reversal, now when
you push the cross travel directional button the trolley will move in the opposite
direction.
Dual Speed: After completing the wiring and when testing for the first time be very
careful when operating the trolley. Conduct a small momentary test by pushing the slow
button in any direction and testing if slow is the first speed, if the trolley moves quickly
you may have wired it incorrectly, go back and check wiring in the motor.