BIRO PRO-9, Руководство по эксплуатации и обслуживанию, Страница: 17 / 40

15
STEP 6:
Place back wire comb T3117 in right hand with the
short horizontal end away from you. Place the comb
finger closest to you (comb finger closest to right hand
cradle end) between the first two feeder blades on the
back blade assembly.
CAUTION: IF COMB FINGERS ARE BENT OR
DISTORTED, REBEND SUSPECT COMB FIN-
GER BACK INTO POSITION USING THE COMB
STRAIGHTENER TOOL, ITEM TA3119.
STEP 7:
Place front comb T3116 in left hand. With short
horizontal end away from you. Insert the comb so the
second and third finger closest to you (comb fingers
closest to right handle cradle end) go between the first
knife blade on the front blade assembly. CAUTION:
THERE SHOULD BE NO COMB FINGERS
BETWEEN THE LEFT HAND CRADLE END AND
THE KNIFE BLADE NEXT TO IT.
Note: this procedure varies upon using other stew blade
assemblies with different spacing.
STEP 8:
Unplug electrical cord. Holding the cutting group’s support handle, begin to insert the assembled cutting
group into PRO-9 Tenderizer. Open safety cover, insert coupling ends first and then rotate the right hand
cradle end back counter-clockwise onto the cutting group supports. Make sure coupling ends are locked into
the driving shafts and then pull down cradle lock lever to firmly secure the cutting group. Close safety cover,
plug in electrical cord, turn on toggle switch, and begin operation.
ASSEMBLY OF PRO-9 STEW/STRIP CUTTING ASSEMBLIES