BCP-760
Operation Guide
Page 15 of 31
The settings for the communication parameters include:
BCP-760
Category
Selection
Default
♦
Baud Rate
150, 300, 600, 1200, 2400, 4800
19200
9600, 19200, 38400, 57600.
♦
Length
7, 8
8
♦
Parity
Even, Odd, None
None
♦
Stop bits
1, 2
1
♦
Flow Control
Xon/Xoff, CTS/RTS, None
None
♦
Protocol
MULTI, OFF (None)
MULTI
♦
Address
A~Y, 0~6
A
Press [
] to select the setting, [ENT] to confirm the setting.
3.BARCODE when selecting Option 3. BARCODE in the Supervisor Mode, Device
Configuration menu, the LCD will display the BARCODE Setup as shown below.
Press [
] or [
] to toggle between settings. Press [ENT] to set.
Setup decoding of BCP-760 supported bar code symbologies
Symbology
Setup Category (
default
)
Code 39
Enable/disable decoding (ON)
Enable/disable full ASCII (OFF)
Send/No-send Start/stop Character (NO SEND)
Enable/disable Check Digit Verification (OFF)
I 2 of 5
Enable/disable decoding (ON)
Enable/disable Check Digit Verification (OFF)
Codabar
Enable/disable decoding (ON)
Send/No-send Start/stop Character (SEND)
Enable/disable Check Digit Verification (OFF)
UPC-A
Enable/disable decoding (ON)
Send/No-send Leading Digit (SEND)
Send/No-send Check Digit (SEND)
UPC-E
Enable/disable decoding (ON)
Send/No-send Leading Digit (SEND)
Send/No-send Check Digit (SEND)
Enable/disable Zero-Expansion (OFF)
EAN-13
Enable/disable decoding (ON)
Send/No-send Leading Digit (SEND)
Send/No-send Check Digit (SEND)
EAN-8
Enable/disable decoding (ON)
Send/No-send Check Digit (SEND)
<< BARCODE SETUP>>
CODE 39
ON
