BIOS AP DVT10U3, Руководство пользователя

Страница: 17 / 62

DVT10U3
－
14
－
5/10/20
Days/Cycle
5/10/20 days cycle
System Patrol
Wait
10S/5S/3S
System Patrol will be started if interval of host commands is larger
than 10S/5S/3S

Fan speed control temperature
Set up temperature criteria for fan speed control
FAN SPEED TEMP
45 deg. C
20, 30, 35, 40, 45*, 50, 55, 60 deg C
When the detected temperature (RAID Core chip) is higher than the FAN SPEED TEMP, the fan will
be turned into high speed. The pre-set temperature is 45 degree and should not be changed.
2.5. Change Network Parameters by front panel operation
You can change network parameters such as Management IP addresses described below by front panel
operation. Nevertheless , Web UI is usually recommended for such requirement if accessible.
ps
）
Please take a memo before you apply to change the setting. Default IP (IPv4) address
is 192.168.50.210. Subnet mask is 255.255.255.0
2.5.1 Method to setup Ethernet IP address by front panel
In case necessary to configure IP address by front panel, you can follow below steps to set it up. It is
recommended to change IP address through Web GUI.
1
．
Press both Mode and Select buttons, power up to enter Setting mode.
ARRAY PARAMETERS
SETTING!
2
．
Press the SELECT button (instead of MODE to set up RAID operational parameters)
Firm ware is
Ver.x.xxx
Firmware version will be displayed
After then, press front Mode button to change network parameters. You will see current IP address
displayed on LCD as below
● IP Address Setup
IP Address
192.168.50.210
By pushing SELECT button, the IP Address will be increased from leftist digit.
The longer you hold the SELECT button, the faster the number is increased.
Push the MODE button to move to next field. (Again Management GUI is recommended)