Bionet Oxy9Wave Vet, Руководство по эксплуатации

Страница: 44 / 48

Oxy9Wave Vet
Operation manual
Ver. 1.52 7.References and Others 44
7-1. Cleaning and Maintenance
Check the items below before operating the equipment.
We do not provide free repair even if the warranty is still valid if the product is contaminated or
damaged due to the use of non-approved dangerous material for washing.
Cables and lead wires can be cleaned with warm, damp cloth and mild soap or isopropyl alcohol
wipes. For more intensive disinfecting (near-sterile), Ethylene Oxide (ETO) is acceptable, but it will
shorten the service life of the cable or lead wire.
Carefully check both frame and sensor after cleaning the Equipment. Do not use worn out or
damaged equipment.
Clean and wipe the frame at least once a month using a soft cloth wet with water and alcohol. Do
not use lacquer, thinner, ethylene, or oxidizer (may damage the equipment).
Make sure both cables and accessories are free of dust or contaminants; wipe them with soft
cloth wet with warm water(40
° ) and at least once a week. Clean them using clinical alcohol.
7-2. Warranty Period
◼
This product is manufactured based on – and has passed – strict quality control and
thorough inspection.
◼
The compensation standard concerning repair, replacement, and refund of the product
complies with the
“ Consumer Protection Law ” announced by the Economic Planning Dept.
◼
We Shall repair or replace any part of the Oxy9 wave Vet that is found to be defective
under usual operating circumstances for free.
◼
This warranty does not apply to any defect caused by improper use, misuse, or abuse.
CAUTION : Do not use acetone or ketone solvents for cleaning; do not use an autoclave
or a steam cleaner.
CAUTION : The decision to sterilize must be made as per your institution ’ s requirements with
awareness of the effect on the integrity of the cable or lead wire.