Bioneer Exicycler 384, Руководство пользователя

Страница: 56 / 78

51
www.bioneer.com
BQ-042-101-12
Revision : 0 (2018-07-05
Exicycler
™
384
IMPORTANT:
Pay particular attention to the Fluorescence test kit when handling. Wear disposable plastic gloves
to prevent contamination on the sealing tape covering 384-well plate. Wipe the surface of the plate
with 70% ethanol when it needs to be cleaned.
NOTE:
Do not vortex the Fluorescence test plate. A small amount of Fluorescence test solution is pre-aliquoted
in each well, and it may be lost while vortexing.
5) Place the Fluorescence test plate in a rack and
centrifuge for 5 minutes.
NOTE:
It is important to centrifuge the Fluorescence test kit prior to use. This will spin down remains of
fluorescence dye on the side of the well and to remove air bubbles at the bottom of the well.
6) Protect the Fluorescence test plate from direct sunlight
after centrifugation. Place the plate directly into
Exicycler
™ 384.
7) Put the Fluorescence test kit back into its packaging and return it to the freezer when the calibration
is done.
IMPORTANT:
The Fluorescence test kit contains photosensitive components. Keep the Fluorescence test kit away
from light during calibration. Put the Fluorescence test plate back into its packaging right away for
reuse.