Reports Structures
42
IS1001 Reader User Manual
Messages To Local Port:
Enabled
Remote Port Protocol:
ASCII
Remote Port Transfer Rate:
Full
Detection:
HDX Tag Detection:
Disabled
Fastag Detection:
Disabled
FDXB Tag Signal Level Detection: Disabled
BioTherm Tag Temperature Detection:Disabled
Detection Counter Enabled:
Yes
Unique Mode:
Disabled
Unique Delay:
60 sec
FDXB Detection Scan Time:
120 ms
VTT Level:
128
Auto VTT Delay:
60 min
Measurements:
Antenna Current Gain:
120
Antenna Current Offset:
110
Memory:
Tags Memory Size:
78583
Status Reports Memory Size:
1023
Store Tags To Memory:
Enabled
Store VTT To Memory:
Enabled
Store Stat. Reports To Memory: Enabled
Reports:
Auto Noise Report Delay:
Disabled
Auto Status Report Delay:
60 min
Diagnostics:
Detection Counter:
0
Tags In Memory:
2 (0%)
Status Reports In Memory:
5 (0%)
Input Voltage:
19.5 V
Exciter Voltage:
11.9 V
Antenna Tuning:
Tuned
Antenna Current:
2.1 A
Tuning Capacitors:
175
Tuning Phase:
381
Tuning Relative Phase:
1
FDXB Signal Level:
74 mV (8%)
Temperature:
27.3 C
Sync. Input Present:
No
Sec. Master Active:
Yes
Active Alarms:
No Active Alarms
INF: End Of Full Status Report
Short Status Report Structure
A short status report contains dynamic diagnostic parameter
s’ information for the IS1001 reader.
It is generated every time an automatic status report is generated. This report is stored in IS1001
reader’s internal memory (if
Save Status Reports to Memory
(
MSR
) setting is enabled) in a form
of comma separated data values string. IS1001 reader can store up to 1,023 status reports in its
internal memory. The stored reports can be dowloaded using the
MED
command.
