– What do I do if the mixer motor does not work?
The mixer motor is protected in two different ways in order to prevent damange on mechanical parts.
– The motor runs normally, but the mixing arms do not move!
There is a shear pin on the motor shaft. When the resistance is too high, the shear pin breaks and must be replaced.
– The motor starts and stops and after a while it starts again by itself, but the mixing arms are still not moving!
The electrical motor has an overheating protection, which activates if the resistance is too high. It will turn itself off.
But it will try again after a while and it will repeat this until the high resistance in the compost has been resolved.
It is usually enough by mixing the compost, using the rake and adding a few litres of water. See “What do I do if the
compost becomes too dry” page 8
– What do I do if the shear-pin breaks?
The shear pin can easily be replaced. The shearpin is not covered by warranty. An extra shear-pin is fixed next to the
mixer motor.
– When do I need to call a qualified electrician?
BioLet is approved for installation in bathrooms. If the main cord is damaged it must be replaced by the
manufacturer or its service people, or another qualified person, to prevent injury. This manual should be
is placed near the toilet.
– Where do I get parts?
Contact your national dealer. Always have the serial number and model ready and what
year it was bought. This information can be found on a sticker on the back of the toilet.
– Check
1
. That the BioLet is
getting enough air through a vent in the outer wall.
2. Make sure the front cover is put on properly.
3. Avoid draughts by not having both windows and vents open at once, or bathroom fan running.
4. That the pipes fit the toilet properly and pipe joints are sealed.
5. That any pipe bends are not more than 45° or more than two bends.
9
Содержание 65a
Страница 1: ...User Manual for BioLet...
Страница 2: ......