BinTec X4100, Руководство по установке

Страница: 24 / 36

Installation of the Expansion Card and Resource Card(s)
2
24 BinTec Access Networks GmbH
Proceed as follows:
➤
Disconnect the power cord of X4100/200/300 .
➤
Undo the screws of the dummy cover or the expansion card installed in the
slot. (see
figure 2-1, page 25 ).
➤
Remove the dummy cover or withdraw the existing expansion card from the
slot.
➤
Keep the two screws of the dummy cover, as these are used for fixing the
expansion card.
Caution!
An extension card must not be installed or replaced during opera-
tion. X4100/200/300 must always be disconnected from the power
supply first, otherwise there is a risk of damaging both
X4100/200/300 and the extension card.
If, however, you carry out the installation of an expansion card
during operation, the guarantee is rendered invalid.
➤
Always disconnect the power cord of X4100/200/300 before
you insert or replace the expansion card.
➤
Do not connect X4100/200/300 to the power supply until the
equipment is completely installed and you have rechecked
the installation.