F
LAN1 to LAN4 connectors for 4-port Gigabit Ethernet switch.
G
AUX. DB9 connector providing access to the device's local console for configuration and
monitoring purposes.
H
RST. Reset button. For further information on how the reset button works, please see
on page 12
I
LED panel.
The LED panel provides status information on the various components (showing whether they are enabled or dis-
abled) and on network activity.
3.1.1.1 LEDs
The following image shows the position of the LED indicators on the front panel of the device:
Fig. 3:
bintec H2 Aut
: LEDs
The meaning of each LED indicator depends on the modules installed. Each LED indicator belongs to one of four
possible modules.
The following table describes the meaning of each LED indicator:
LEDs 1..4
When a WWAN module is installed in one of the slots, the "X" LED provides status
information as follows:
Off -> system stopped.
Red -> the interface is unavailable because it is being installed, it is disabled
(shutdown), or it has failed a self-test.
Amber -> idle.
• Rapid blinking. The device has not, or cannot, register with the network.
• Slow blinking. GSM connection (GPRS).
• Steady. WCDMA (UMTS / HSDPA) connection.
Green -> connected. Blinking: connection data activity.
LEDs 1..4
When a WLAN module is installed in one of the slots, the "X" LED provides status
information as follows:
Red -> interface down.
Green -> interface up.
Blinking (green/red) -> activity/maintenance.
U
USB status LED. When an external dongle is used, this LED provides status in-
bintec elmeg GmbH
3 Components and power supply
bintec H2 Aut
5
