8
VRF180913 Rev. A
www.bindicator.com
8
Note: The VRF II Series incorporates pluggable terminal blocks for ease of connection. If the terminal block is
unplugged while making connections, ensure it is seated properly when reinstalled.
5. Attach power leads to terminal block as shown in Figure 5.
6. Check that all wires are held tightly in place by lightly pulling each conductor.
Main Relay Connections
7. Refer to Figure 3 or 4 and 6 when connecting to the main relay.
8. Pull approximately 4.5” (11.43 cm) of cable through conduit and strip
1
/
4
” (6 to 7 mm).
9. Attach leads to terminal block as shown in Figure 5.
10. Check that all wires are held tightly in place by lightly pulling each conductor.
For STANDARD models skip to Step 15; for ADVANCED models continue to Step 11.
Auxiliary Relay Connections
11. Refer to Figure 3 or 4 and 7 when connecting to the auxiliary relay.
12. Pull approximately 5.5” (13.97 cn) of cable through conduit and strip
1
/
4
” (6 to 7 mm).
13. Attach leads to terminal block as shown in Figure 5.
14. Check that all wires are held tightly in place by lightly pulling each conductor.
15. Reinstall the gasket, if necessary.
16. Replace cover and tighten screws to 60 in-lb (6.8 n-m) of torque.
VRF II SERIES REMOTE MODEL ONLY
Input Power Connections
1. Refer to Figures 3 or 4 and 5 when connecting input power to the unit.
2. Loosen set screw that locks cover in place.
3. Unscrew the housing cover and remove.
Note: Two threaded female conduit openings are provided in the remote housing to separate input and output
wiring from the remote probe wiring.
4. Pull approximately 6” (15 cm) of cable through conduit closest to grounding bracket and strip as follows:
a. Ground –
3
/
8
” (9 to 10 mm)
b. Power Leads –
1
/
4
” (6 to 7 mm)
5. Attach incoming ground lead to grounding bracket as shown in Figure 5.
Note: The VRF II Series incorporates pluggable terminal blocks for ease of connection. If the terminal block is
unplugged while making connections, ensure it is seated properly when reinstalled.
6. Attach power leads to terminal block as shown in Figure 3 or 4.
7. Check that all wires are held tightly in place by lightly pulling each conductor.
Содержание VRF II Series
