BIMG Metvisa FTG.150B, Инструкция по эксплуатации

Страница: 27 / 44

27
PROBLEMS POSSIBLE CAUSES SOLUTIONS
Equipment will not turn on
Lack of electricity or gas.
Check for power in the mains or gas in the cylinders.
Check that the power cord is plugged into a wall
outlet.
Voltage different from mains
voltage.
Send the equipment to the nearest authorized
service station or contact the factory.
Miscellaneous electrical
problems (motor / capacitor,
contactor, wiring, fuse, electric
switch, power cable, buttons
and burned resistance).
Open door.
The door has a safety system that prevents fan
operation and heating if it is open, close the door and
switch on the oven again.
Knob axis does not trigger
electric switch. Send the equipment to the nearest authorized
service station or contact the factory.
Oven does not heat or
hang in the middle of
operation
Lack of electricity.
Check for power on the network.
Check that the power cord is plugged into a wall
outlet.
Miscellaneous electrical
problems (motor / capacitor,
contactor, wiring, fuse, electric
switch, power cable, buttons
and burned resistance).
Send the equipment to the nearest authorized
service station or contact the factory.
Burner(s) will not light
Burner(s) will not
light
Lack of gas.
Evaluate whether there is gas in the cylinder,
whether the gas cylinder register is open, whether
the gas hose is connected and whether the gas
regulator is open. Never install only a single gas
canister, freezing may occur with this canister.
Clogged burner.
Unclog burner holes as per instruction in item 5.2
(Maintenance)
Send the equipment to the nearest authorized
service station or contact the factory.
Gas leakage.
See below for possible causes and solutions for
gas leakage (pg. 28).
Solenoid valve damaged.
Send the equipment to the nearest authorized
service station or contact the factory.
Gas leakage.
Burst valve, loose or broken.
Send the equipment to the nearest authorized
service station or contact the factory, as there are
risks of accidents.
Valve nozzle out of position.
Send the equipment to the nearest authorized
service station or contact the factory, as there are
risks of accidents.
Faulty gas canister.
Check for leaking gas using soap suds only. If there
is a leak, have the technician repeat the installation.
If leakage persists, move the canister to a well-
ventilated area and notify the dealer or distributor of
the canister.
Gas cylinder installed
horizontally.
Install the canister upright. Never turn, throw or tilt
the cylinder, as the gas may flow in the liquid phase,
canceling the function of the pressure regulator,
which can cause serious accidents.