MWEB ADSL Wi-Fi Router
MW/W40 V4.0A-090115
Page 5
The Ethernet Port # 4 can be used as a console port. You need the special
console adapter, included in this package, to connect the LAN cable of Port 4
when connecting to a PC’s RS-232 port (9-pin serial port). Note that the console
port is for emergency use only, and should not be used by default.
The Rear Ports
Port
Meaning
1
Power Switch
Power ON/OFF switch
2
Power
Connect the supplied power adapter to this jack.
3
RESET
After the device is powered on, press it to reset the device or
restore to factory default settings.
1-3 seconds: reset the device
6 – 8 seconds: restore to factory default settings (this is useful
when you have forgotten the router’s administrative password).
Note: If the reset button is pressed for more than 10 seconds
the device will need to be power cycled before normal
operation can be resumed.
4
WPS
Push WPS button to trigger Wi-Fi Protected Setup function.
5
LAN (YELLOW)
1 — 4
(RJ-45 connector)
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
LAN ports when connecting to a PC or an office/home network
of 10Mbps, 100Mbps.
6
DSL (RED)
Connect the red RJ-11 cable to this port when connecting to
the phone-line jack on the wall via the red “DSL” port on the
splitter.
7
Antenna
Connect the detachable antenna to this port.
Содержание MWEB W40
Страница 1: ......