Operating manual No.
057-2-6-0010-R0
Page 10
Version 2021
EN
2
Machine description
2.1
Machine name
The HYDRAULIC PRESS described in this manual has been specifically designed for the use in
operations that require a compression force.
Basically it consists of three units:
-
THE PRESS BODY
-
THE MANUAL PUMP
-
THE HYDRAULIC CYLINDER: designed for the specific needs of use of the press. In
addition to the special attention paid to the internal surfaces and the stem, special low
friction seals are used to optimize the operations that require particular precision in the
pressing action.
2.2
Press identification
The Press has an identification plate fixed in a visible way as indicated in the following Figure 1.
Figure 1 – press identification
Refer to these details for ordering spare parts and for any kind of contact with the manufacturer
It is absolutely forbidden for the user to remove or alter this plate. Any modification or removal of
the plate will void any warranty.
The machines can be subject to updates or small aesthetic changes and therefore have different
details than those shown, without prejudice to the descriptions and procedures contained by this
Manual.
2.3
Intended use
The press is intended exclusively for pressing operations such as: straightening, inserts fitting (e.g.
bushings, bearings, brasses, etc.), extraction of inserts.
