Operating Manual Nr.
057-2-6-0014-R0
Page 19
Version 2021
EN
It is recommended that the unloading or handling operations be carried out
with a forklift truck by a single Operator equipped with workshop gloves,
safety footwear and protective helmet, as required by current regulations.
This operator must pay the utmost attention to all Transport phases.
Do not allow any other person to stand in the operation area of the forklift
truck in order to prevent the accidental fall of the boxes.
In any case, the utmost attention must be paid to the vehicles and people in transit during the
entire unloading phase.
Make sure there are not many holes in the floor or on the high slope ramps for the vehicle
used, in relation to the load carried; always proceed at low speed with the means of
Transport.
The unloading from the wooden pallet of the cardboard packaging containing the lifting
bench, to be carried out manually by no less than four operators equipped with workshop
gloves, must be done near the location where the machine will be installed.
4.4
Goods receipt and checks
The packaging is made of suitable material and is carried out by expert personnel, but during
the journey it may get deteriorated or damaged.
Upon receipt of the machine, immediately check if the packages are clearly damaged. If this is
the case, accept the goods with reserve, by making photographic evidence of any damage.
Open the box by cutting the clips and the closing adhesive tape.
Make sure all the material shown on the delivery note is actually present.
Make sure the parts of the machine have not been damaged during Transport and notify,
within 5 days of receipt, any damage to the Carrier by REGISTERED LETTER (and notify Bike-
Lift Europe s.r.l.), by presenting photographically documented evidence.
4.5
Storage
Before being unpacked and installed, the machine must be stored in a suitable
environment in order not to alter its operation.
Store the packed machine in a closed or covered area above the ground by using
sleepers or similar objects.
Room temperature and humidity: -5°/75 ° C Relative humidity between 30% and 90%.
Do not overturn the packaging.
If the machine is stored without packaging, it must be positioned firmly on wooden
sleepers and covered with a cloth.
Do not stack anything on the machine.