Bike-Lift M516-001, Руководство по эксплуатации и обслуживанию

Страница: 27 / 50

Operating manual number
057-2-6-0001-R0
Page 27
Version 2021
EN
7 Operation section
Figure 6 – general model of a lifting platform
7.1 Loading operations
Before installing the vehicle on the platform, it is essential to use the wheel stop (Figure 6,
[1]), to check that the work surface (Figure 6, [1]) is
completely lowered and the ascent ramp
(Figure 6, [3]) is properly positioned.
1- Load the motorcycle on the work surface [2], by passing it on the ascent ramp [3];
2- Place the motorcycle on its centre kickstand (if it does not have a central kickstand,
use one of our rear kickstand).
Do not lift the motorcycle leaning on the side
kickstand;
3- Tie the motorcycle with the belts (available on request) to make it more stable.
CAUTION: Never lift the load before making sure it is firmly fastened to the
platform with belts.
Always check during lifting that the load does not slope and unbalance;
During the ascent/descent phase the operator is required to distance from the
lifting platform according to the length allowed by the control panel cable.
Proceed with the lifting operation of the structure according to the following, depending on
the type of lifting available.
Once the working height has been reached, slightly lower the lifting platform in order to make
sure that the safety bar (Figure 6, [4]) is leaning against the stop locks; otherwise, continue
the ascent until the bar exceeds the stop locks located at the base of the lift for the chosen
working height;
CAUTION: Do not operate without the safety bar.
If necessary, the ascent ramp can be removed, to allow the operator to work without
disturbance even in the rear part of the bike.
3
2
4
1