Operating manual No.
057-2-6-0015-R0
Version 2021
P. 16
EN
4
Transport and handling section
4.1
Transport, handling and storage
WARNING:
Disseminate the instructions described in this chapter to all
personnel involved in the transport and handling of the machine.
For safety reasons, the moving parts must be locked before transport.
4.2
Packaging and transport
The machine is supplied with two cardboard packaging placed on a wooden pallet. A box
containing the pole, and the other containing the base of the lift.
4.3
Unloading and handling
All lifting and unloading operations must be carried out in compliance with current safety
regulations.
The cardboard packaging must be lifted using a forklift truck or a pallet jack.
During the unloading phase, in any case, pay attention to vehicles and people in transit.
It is recommended that the unloading or handling operations to be carried out
with a forklift truck or pallet jack by a single operator equipped with workshop
gloves, safety footwear and protective helmet, as required by current regulations.
This Operator must pay maximum attention to all transport phases.
Do not allow any other person to stand in the operating area of the forklift truck in
order to prevent the accidental fall of the boxes.
Make sure there are not many holes in the floor or on the high slope ramps for the vehicle
used, in relation to the load carried; always proceed at low speed with the means of transport.
The unloading of the cardboard packaging containing the pole and the base of the lift can be
carried out manually by no less than two operators equipped with workshop gloves, and must
be done near the location where the machine will be installed.
4.4
Receipt and check
The packaging is made of suitable material and is carried out by expert personnel, but during
handling it is possible that it may get deteriorated or damaged.
Upon receipt of the machine, immediately check if the packages are clearly damaged.
If so,
accept the goods with reservation, by preparing photographic evidence of any damage.
Содержание LEB-50 LIFT
