Bike-Lift CU500-003, Руководство по эксплуатации и обслуживанию

Страница: 28 / 35

Operating Manual no. 057-2-6-0016-R0
Version 2020
P. 28
EN
8.4
Cleaning
8.4.1 Initial cleaning
The machine does not require particular initial cleaning, but it is a good practice to clean the
transit areas of the motorcycles by removing the oils and dust to prevent the slip during loading.
Wear water-repellent gloves. Perform the cleaning operations wearing anti-cut
gloves resistant to the substances used (follow the safety data sheet).
WARNING: Make sure that there are no foreign bodies inside the lift and especially
in the sliding guides of the scissors.
WARNING
: Any cleaning operation must be carried out with the machine
disconnected from the power source.
Keep the work area of the operators clean. The
cleaning operations concern:

The machine in general;

The operator's standing areas.
Dispose the liquids and consumables used in the appropriate landfills, according to the legislation
of the Country.
The cleaning of the lift can be carried out by personnel without specific technical skills, who
however know the main characteristics of the machine in order to avoid hazardous situations.
8.4.2 General cleaning of the machine
Perform the general cleaning of the machine weekly with the utmost care.
Remove foreign substances: you can use non-corrosive detergents for ferrous and rubber material.
These detergents must not be harmful to the operator (follow the instructions contained in the
safety data sheets of the substances used, also for the selection of personal protective equipment
worn by the operator during work).
The use of water jets and flammable liquids is
FORBIDDEN. We recommend using self-cleaning
cloths.
The support surfaces and locking blocks of the safety bar must be carefully cleaned to remove
traces of oil or grease.