Bike-Lift CU500-003, Руководство по эксплуатации и обслуживанию

Страница: 20 / 35

Operating Manual no. 057-2-6-0016-R0
Version 2020
P. 20
EN
5.1 Ascent ramp assembly
Hook the ascent ramp to the leg of the lift (Figure 5, [1]) when the work surface is at a height less
than 40 cm from the ground. During the ascent the ramp is blocked and will consequently move
toward the lift.
1
Figure 5
–
Ascent ramp
In the same way, in order to allow the ramp to be dismantled, the work surface must be
positioned at a height less than 40 cm.
5.2 Power supply
Electric pump - Connect the electric cable to the power grid using the plug (not supplied),
according to the regulations in force in the country of use. The socket must be grounded.
TECHNICAL DATA OF THE ELECTRIC MOTOR:
Use voltage: 220/230 V. Frequency: 50 Hz. Absorbed power: 1kW Use
voltage: 110/115 V. Frequency: 60Hz. Absorbed power: 1kW
WARNING : In the electronic or electro-hydraulic version, the lifting platform is
equipped with an electronic board that transforms the low-voltage current to
prevent the electrocution risk. A fuse calibrated on the amperage of the stable
230V power supply is located inside this board.
It is forbidden to replace/tamper with this fuse with one of a higher
resistance/amperage.