Operating Manual no.
057-2-6-0016-R0
Version 2020
P. 18
EN
This Operator must pay maximum attention to all transport phases.
Do not allow any other person to stand in the operating area of the forklift truck in
order to prevent the accidental fall of the boxes.
During the unloading phase, in any case, pay attention to the vehicles and people in transit.
Make sure there are not many holes in the floor or on the high slope ramps for the vehicle used, in
relation to the load carried; always proceed at low speed with the means of transport.
The unloading from the wooden pallet of the cardboard packaging containing the lifting bench,
carried out manually by no less than four Operators equipped with workshop gloves, must be
done near the location where the machine will be installed.
4.4
Receipt and check
The packaging is made of suitable material and is carried out by expert personnel, but during the
trip it is possible to be deteriorated or damaged.
Upon receipt of the machine, immediately check if the packages are clearly damaged.
If so, accept
the goods with reservation, by preparing photographic evidence of any damage.
Open the box by cutting the clips and the closing adhesive tape.
Make sure all the material shown on the delivery note is actually present.
Make sure the parts of the machine have not been damaged during transport and notify any
damage to the Carrier by REGISTERED LETTER within 5 days of receipt (and notify Bike Lift Europe
s.r.l.), by presenting photographic evidence.
4.5
Storage
Pending to be unpacked and installed, the machine must be stored in a suitable environment in
order not to alter its operation.
Store the packed machine indoors or in a covered area above the ground by using sleepers
or similar objects.
Ambient temperature and humidity: -5°/75 ° C Relative humidity between 30% and 90%.
Do not overturn the packaging.
If the machine is stored without packaging, it must be positioned firmly on wooden
sleepers and covered with a cloth.
Do not stack anything on the machine.
Содержание CU500-003
Страница 31: ...Operating Manual no 057 2 6 0016 R0 Version 2020 P 31 EN Solenoid valve Oil plug Figure 11 electric motor ...
Страница 33: ...Operating Manual no 057 2 6 0016 R0 Version 2020 P 33 EN SPARE PARTS TECHNICAL DRAWINGS ...
Страница 35: ...EN NOTE NOTES Operating Manual no 057 2 6 0016 R0 P 34 Version 2020 ...