8
4. Setting of the tightening torque
In case of tightening a collet chuck with a different size, replace the adapter or modify the wrench’s settings.
Before tightening, always check the setting and be sure to execute the tightening operation
with the correct setting.
If the operation is performed with the wrong setting, the proper tightening torque will not be reached becoming
cause of damages for the collet chuck or the torque wrench.
Caution
1
）
Changing the operation mode
Working mode’s screen
Setting mode’s screen
The LCD will change from the “Working mode” display to the “Setting mode” dis-
play. In the "Setting mode" display, the code of the collet chuck is displayed for
2 seconds and then its recommended tightening value is also displayed.
2
）
Changing the settings
The LCD switches to the “Working mode”. It is now possible to use the new
setting for the tightening operation.
3
）
Confirming the setting
If the MODE button is not pushed within 5 seconds, the LCD
switches automatically to the “Working mode”.
In this case, the operation executed on the “Setting mode” is
cancelled and the device switches back to the previous setting.
Push the MODE button on the operation
panel to switch to the “Setting mode”.
Push the buttons on the operation
panel to modify the settings.
If the button is pushed, the settings will be displayed on the LCD
following the order below.
(Pushing the button will display the settings in the opposite order.)
Push 1 time the button to display
the successive setting.
Push 1 time the button to display
the previous setting.
While the intended setting is displayed
on the screen, push again the MODE
button to confirm it. The displayed
contents become the current setting.
n06
→
n08
→
n10
→
n13
→
n16
↑ ↓
↓
E13
←
E10
←
E08
←
E06
←
n20
