4. Preparation before use
4-1 Setting
If you have much temperature difference between the inventory location and
workshop, leave the unit in the workshop for the appropriate time to adapt it.
(e.g. In case of 10C difference, 15-20 minutes is required.)
4-2 Calibration
Note:
①
Depending on the environment and condition of base level, the LED does
not always stay in the center (0 position). Make sure to calibrate the unit
depending on the environment to be used.
②
Place the unit in the center of base level. Before placing the unit on the
base level, make sure to remove the oil and dirt on the bottom of Level
Master as well as those & scratch marks on the base level.
③
Mark 4 reference marks (2 marks for X-axis, 2 marks on Y-axis) on the
base level according to 4 reference marks on Level Master’s base part.
④
Turn on the Power switch.
⑤
Calibrate the Level Master as explained below:
Mark
4 reference marks