Big Daishowa DynaForce, Руководство по эксплуатации

Страница: 14 / 24

12
Install the measuring device in the machine spindle manually. Measured drawing force is indicated on
the display unit. Unit is kN. (10kN = 1,020kgf)
"oL/-oL" or "Ad/-Ad" indication represents input overshoot. Refer to the Table 1 shown below and make a
measurement once again. If you still have trouble, contact our agent.
2-5 Installation to machine spindle
2-6 Peak-hold measurement
2-7 End of measurement
2-8 Replacement of batteries
● Subsequent measurement by using the same measuring device
● Subsequent measurement by using another measuring device
Table 1 Factors and solutions of input overshoot
Factor Solution
Replace the pullstud with a correct one.
Clean tapers.
Refer to "3-2 Sensitivity calibration entry [F-3]" and configure the setting.
Select
【 MEAS 】 mode.
Wrong pullstud
Dirt stuck between tapers
Error in sensitivity calibration
Measured in STRAIN mode
Max. measured value is maintained and displayed.
1. After zero resetting, push HOLD .
"HOLD" is displayed on the LCD to show that peak hold measurement is in progress.
2. Install the measuring device in the machine spindle and make a measurement. By pushing
HOLD again, peak hold mode is ended and the current input value is indicated.
To turn off the power, push and hold the 【 POWER 】 switch.
Open the battery box by sliding the cover.
2 pcs. of AA alkaline or manganese batteries are used exclusively.
No set up is required, as all the previous set up are not erased even if the power is turned
off or batteries are replaced.
Sensitivity calibration entry is required for both the rated capacity and output, as they vary
depending on the measuring device. Refer to "3-2 Sensitivity calibration entry [F-3]" and
configure the setting.
CAUTION
Clean tapers of both machine spindle and measuring device before
installation.
Care should be taken not to get a finger caught in the spindle when
installing the measuring device.
●
●