Big Bike Parts TireGard, Руководство пользователя

Страница: 10 / 23

9
2. Installation of the External Sensors (See page 12 for Installation of the Internal Sensors)
Each sensor is designed specifically for the tire location as denoted by its number; you have to
make sure the sensors are installed in their specified positions. See diagrams starting on page 4.
When inserting the batteries into the sensors, do not mix up the Front (1) and Rear (2) sensor caps.
Each sensor is marked on its cap and within its body indicating its position on the motorcycle.
Insert Batteries in External Sensors
Battery Installation for Tire Pressure External Sensor:
A. Remove sensor cap by rotating counter-clockwise.
B. When inserting lithium battery make sure battery polarity is correct.
Immediately the LCD Receiver/Monitor will receive signals from the corresponding sensors and
report the pressure value on the screen. At first, you will find the value shows “00.0”. It is because
sensors have not been mounted yet.
Note: After removing the battery, you will need to let the system reset. Please allow it to sit for 10
seconds before inserting the battery again.