BIG BEN CYBERBIKE, Инструкция пользователя

Страница: 13 / 32

06
Adjusting pedal resistance
You can adjust the pedal resistance on your Cyberbike™ using the knob loca-
ted at the base of the handlebar tube.
• Rotate the knob in an anti-clockwise direction (towards the “-”) to decrease
resistance when pedalling (See Fig 10).
• Rotate the knob in a clockwise direction (towards the “+” ) to increase resis-
tance when pedalling (See Fig 10).
• Pedal resistance can also
be adjusted when pedalling.
4.ADVANCED FUNCTIONS
4.a. Programming:
4.a.I. How to programme the buttons:
• Press the “PROGRAM” button. The LED underneath this button will come on.
• Press the button or the direction that you wish to assign to another button
(e.g. the A button). The LED will start to flash steadily.
• Press the button that you now wish to use (e.g. the B button). The LED will flash
rapidly for 2 seconds before going off.
• Pressing the B button will now carry out the action previously assigned to the
A button.
You can then reprogram any other button or direction as you wish.
4.a.II. Cancelling programming:
• Press the “PROGRAM” button once. The LED will come on.
• Press the programmed button (e.g. the B button). The LED will start to flash
steadily.
• Press the programmed button again (or the «PROGRAM” button). The LED will
flash rapidly for 2 seconds before going off.
• The B button has now reverted to its original function.
4.a.III. Cancelling all programming:
• Press the “START/PAUSE” and “PROGRAM» buttons at the same time and hold
down for 3 seconds. The LED located below the «PROGRAM” button will flash
for 3 seconds.
4.b. Calibrating the handlebar
• Press the «PROGRAM” the “Y” button for 3 seconds. The LED located
below the “PROGRAM” button will flash.
• Centre the handlebar.
• Press the “Y” button. The LED located below the “PROGRAM” button will now
flash more rapidly. The central position of the handlebar has now been set.
• Turn the handlebar to the left or right as far as it will go.
• Press the «Y” button. The LED located below the “PROGRAM” button will flash
for 3 seconds before going off. The handlebar calibration process is now
complete.
Restoring the manufacturer’s calibration (default setting):
• Press the “START/PAUSE” + “PROGRAM” buttons and hold down for 3 seconds.
The LED will flash for 3 seconds. The handlebar calibration will revert to its
default setting and any previous programming will be deleted.
4.c. Gamecube™ / Cyberbike™ modes
Use the Gamecube™ mode when you want to play with a Gamecube™/ Wii™
game. When you want to play with your Cyberbike™ game use the Cyber-
bike™ mode (See Fig 11) .
CONFIGURATION:
The A / B / X / Y / L / R / Z buttons, the directional pad and analog joysticks
carry out the same actions as those on a traditional Gamecube™ controller.
Brake lever: the brake lever sends back the signal from the «B» button, and can
also be reprogrammed.
4.c.I. Gamecube™ mode
In Gamecube™ mode, FORWARD pedalling is the same as pressing the A but-
ton.
In Gamecube™ mode, REVERSE pedalling is the same as pressing the B button.
EN
G
LIS
H
CYBERBIKE GAMECUBE TM TM
ES
PA
Ñ
O
L
FR
A
N
C
A
IS
Fig 10
Fig 11