BIG ASS FANS 8'-24' Powerfoil X, Руководство по установке

Страница: 25 / 72

8’ - 24’ POWERFOIL® X
WWW.BIGASSFANS.COM ©2011 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED
19
WWW.BIGASSFANS.COM ©2011 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED
8’ - 24’ POWERFOIL® X
Installing Guy Wires
Guy wires may not be included in your fan order. They are intended to constrain the fan’s lateral movement and
are included with fans that have extension tubes 4 ft (1.2 m) or greater in length.
ATTENTION: If installing a VESDA system, do not install airfoils until all VESDA piping is installed.
1. Attach Locking Carabiner to Motor Assembly
Secure the locking carabiner to the guy wire clip on the motor as
shown.
Securely tighten the carabiner.
2. Attach Beam Clamp
Attach the beam clamp to an I-beam or angle iron. The guy wire must be
at a 30°-45° angle from the roof to the extension tube. Place the beam
clamp accordingly.
Fasten the small eyebolt and nut onto the beam clamp. The nut will be on
the outside of the beam clamp.
Loop the guy wire through its crimped end to secure it to the eyebolt as
shown.
Gripple/Eyebolt Hardware (BAF-Supplied):
a. 1/4” Beam Clamp
b. 1/4-20 x 1” Eyebolt
c. 1/4-20 Hex Nut
d. Guy Wire
30˚- 45˚
Beam Clamp
a
d
c
b