CONSTRUCTING EXTENSION TABLE
ASSEMBLY (DELTA SAWS ONLY)
FOR ALL OTHER SAWS, PROCEED
DIRECTLY TO PAGE 7, STEP 1.
DISCONNECT THE SAW FROM
THE POWER SOURCE!
FRONT RAIL TO SAW
1. Assemble front rail (A) Fig. 5 to the front edge of the saw
table using the two 5/16-18 x 1-1/4” long flat head Phillips
screw, flat washer, 3/8” lock washer and 5/16-18” hex nut (B)
supplied. Screws are inserted throught the two larger counter-
sunk holes in the front rail and into the two holes in the front of
the saw table and fastened with the flat washer, lock washer
and hex nut. IMPORTANT: Do not tighten front rail mounting
hardware at this time.
FOR DELTA CONTRACTORS & HYBRID SAWS ONLY
Hang the on/off switch from the front rail mounting bolt on the
left side of the saw, as shown in Fig. 6, before putting on the
flat washer, lock washer and hex nut.
2. Using template (C) Figs. 5 & 7, Check and adjust the front
rail on both sides of the saw blade as shown, to make sure the
rail is parallel with the table surface. The horizontal portion of
the rail should be down from the top of the table surface
2-27/32”.
Tighten the front rail mounting hardware when
you are certain the rail is set at the proper depth.
4
Fig. 4
Fig. 5
Fig. 6
A
B
C
