2
NOTICE
Important safety message relating to equipment
damage only.
PRODUCT SAFETY INFORMATION
WARNING
1.
Meter assembly, interconnect cable assembly, and live line
tool adapters shall be considered
non-insulating
. Do not let
live line tool fittings come in contact with energized or
grounded conductors.
The live line tool adapters, fittings,
and handles shall not be used on any other devices.
2.
Use appropriate length live line tools for voltage being worked
and maintain minimum approach distances as outlined in
OSHA 1910.269, Table R-6.
3.
All Phasing Meters and Voltage Detectors manufactured
during and after
2007 will have a limit mark engraved on the
high voltage probe(s) 2.5 inches from the tip to indicate to the
user the physical limit that should not be exceeded when
approaching and contacting an electrical conductor or other
electrical test points. Zero Ohm insulated adapters (81280IE)
should be used if limit mark will be exceeded.
4.
This equipment should be used only by qualified employees,
trained in and familiar with the safety-related work practices,
safety rules and other safety requirements associated with the
use of this type of equipment.
5.
These instructions are not intended as a substitute for adequate
training, nor do they cover all details or situations which could
be encountered when operating this type of equipment.
6.
Before operating this equipment, read, understand and follow
all instructions contained in this manual. Keep instructions
with equipment.
INSPECTION & MAINTENANCE BEFORE USE
WARNING
1.
Prior to using any high voltage test equipment a careful
inspection should be made to ensure the unit is free from any
contaminants such as dirt, grease, etc. and that there are no
apparent physical damages.
2.
High voltage probe assemblies shall be wiped clean prior to
each use with a silicone impregnated cloth and kept clean and
