Bien Air 1700544-001, Инструкция по эксплуатации, Страница: 67 / 84

ENG
62
NOTES
1 Save and create buttons are disabled if a lock is set (see
chapter “13.7 Settings” on page 45).
2 All parameters can be changed and saved directly in the op-
erative screen (except if a lock is set).
3 Irrigation level button is hidden if pump control kit is
not installed. To install it, please contact a service engineer certi-
fied by Bien-Air Dental SA.
4 If the entered value is out of range, the maximal or minimal
value will be indicated.
5 The handpiece ratio is red-colored for multiplication gears
and blue-colored for direct-drive, and green-colored for reduction
gears.
6 The operative screen always displays the selected handpiece
ratio.
7 The irrigation value is set for each operation. The default val-
ue of the irrigation level is irrigation OFF for Implant operation.
8 The operative screen always displays the selected irrigation
level value. For exemple correspond to an irrigation level
value of 60%.
FIG. 5
When the power demand of the MX-i LED micromotor is
excessive, the operative screen displays the overheating symbol
. In this case the iOptima
INT
unit automatically lowers the
torque in order to avoid overheating of the MX-i LED micromotor.
To restore maximum torque, allow the motor to idle or stop for a
few seconds.
16.2.2 Handpiece ratio
FIG. 6
Tap and select the handpiece ratio.
⚠
CAUTION
Verify that the handpiece corresponds to your selection.
Note 5 - 6
16.2.3 Irrigation level
FIG. 7
Slide or tap the appropriate dot to set up the irrigation level.
6 levels of adjustment are possible from 0 ml/min (OFF) to 120
ml/min.
Note 3 - 7 - 8
FIG. 6 FIG. 7