YV30R
11
Caution: Consult your doctor before beginning to use this appliance. This advice is
especially important for those suffering from health problems.
SAFETY INSTRUCTIONS.-
This product must have an earth connection. In the event that the appliance malfunctions then the
earth connection will redirect the electrical current away from the machine and reduce the risk of
an electrical shock. This product is supplied with a mains cable that has an earth wire and a plug
with an earth pin. The plug must only be used with an appropriate wall socket, installed correctly
and connected to earth, in accordance with local regulations.
DANGER!
If the equipment is not earthed correctly then there is a risk of electrical shock. If in
doubt, get an electrician or technical specialist to check that the earth connection is correct. Do not
modify the plug supplied with the equipment, if it does not fit the wall socket then get an electrician
to install an electrical socket that does.
This product must only be used on a 220-240 volt circuit, with an
earthed socket similar to that shown in Fig.A. Make sure that the
appliance is only connected to a wall socket with the same pin layout
as the plug. Do not use an adaptor with this appliance.
Always observe the following recommendations:
1
Never use accessories not recommended by the manufacturer.
2
Do not use the machine if the mains cable becomes damaged or worn.
3
Keep the mains cable away from hot surfaces.
4
Do not use the machine outdoors.
5
To unplug the machine, first put the switch to the “0” position and then unplug it from the wall
socket.
SAFETY BREAKER.-
This model is equipped with an electronic circuit breaker to protect both the electronic and
electrical circuits.
This safety device (fuse) will be automatically triggered if the unit is subjected to abnormal force or
heat.
1.-
Set switch (L), located on the casing, to the “0” (OFF) positionFig.B.
2.-
Change the fuse (C) (7 Amp).
3.-
Next, set switch (L) to the “I” (ON) position and the unit will be ready for use again.
Plug the unit into a wall socket with an EARTH terminal. Set switch (L) to Position [1].
Fig.B
Содержание VIBROBOOST GS YV30R
Страница 2: ...YV30R 2 Fig 1 Fig 2...
Страница 3: ...YV30R 3 Fig 3...
Страница 4: ...YV30R 4 Fig 4 Fig 5 Fig 6 Fig 7...
Страница 40: ...YV 30R...
