BH FITNESS H852, Инструкция по сборке и эксплуатации

Страница: 14 / 40

14
6. SWING HANDLE ASSEMBLY.-
Place the swing handle (86) in the
slider seat (77), as shown in (fig 6)
place the bolts (143) along the
washers (144) and tighten securely.
7. FITTING THE SADDLE
Place the saddle (126) close to the
slider seat (77) as shown in (fig 6).
Insert the screws (143) along the
washers (144) and tighten securely.
8. ATTACHING THE BACKREST
Place backrest as shown in Fig 8 and
place the screws (142) along the
washers (114) and tighten securely.
Place the handlebar (105) on the
backrest tube (102). Insert the screws
(141) along the washers (144) fig 8
and tighten securely.
9. FITTING THE MONITOR.-
Next, connect terminals, sticking out of
the handlebar post (4) and (5), and
terminals, sticking out of the monitor
(1), Fig.8 a-b.
Place the monitor (1) on top of the
plate on the main post (3), as shown
in Fig.8 a-b, making sure not to pinch
the wires.
Use supplied screws (2) to hold the
monitor in place, Fig.8.
10. LEVELLING.
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (125) up or down, as
shown in (Fig 9).
11. MOVEMENT & STORAGE
The unit is equipped with wheels (116)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
(Fig 9). Store your unit in a dry place,
preferably not subject to changes in
temperature.
12. MAINS CONNECTION H857
Insert the jack (g) on the transformer
(130) into the connection hole (h) on
the main body (16) (bottom, rear of the
machine) and then plug the
transformer into a 230 V mains supply,
(Fig 10).
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE