11
ASSEMBLY INSTRUCTIONS
Figure 1
Take the appliance out of its box and
make sure that all of the pieces are
there: (1) Main frame; (2) front stand
with wheels; (3) rear stand with
levelling blocks; (10) “U” type
handlebar; (11) electronic monitor;
(12) top handlebar (left); (13) top
handlebar (right); (16) Pedal arm (left);
(17) Pedal arm (right); (4) slot head
bolt M10x60; (5) corrugated washer
10.5 x 25; (6) cap nut M 10; (18) flat
washer M-8; (19) Allen screw M8x15,
(20) corrugated washer 8.5 x 22; (21)
Allen screw M6 x 15; (22) flat washer
M-6; (23) Self tapping screw 5 x15;
(37) screwdriver ended scanner; (38)
ring spanner L13~17; (39) Allen key
(hexagonal) L4; (36) bottle holder.
Figure 2
A)
Fit the rear stand (3) onto the
main frame (1), attach and tighten the
slot head bolts (4) with the spring
washers (5) and the cap nuts (6),
using the ring spanner.
B)
Fit the front stand (2) onto the
main frame (1), attach and tighten the
slot head bolts (4) with the spring
washers (5) and the cap nuts (6),
using the ring spanner.
Figure 3
A)
Stand the main post (7) upright,
Insert the top tension control cable
(29), as shown in the Fig. (III), and
then pull the cable until It fi ts Into the
slot, see Fig. ( IIIA ).
B)
Connect the central sensor cable
for the monitor (28) and the end of the
bottom cable (30) individually, as
shown in diagram (II).
C)
Fit the brake cable and the monitor
cable. stand the main post (7) upright
and slide it down over tube (a),
making sure not to catch any of the
cables.
D)
Unfasten the screw (34) at the back
of the tension controller (35), fit the
tension controller (35) onto the main
post (7) and retighten the screw (34)
as shown in diagram (I), using the
screwdriver ended spanner. Check
that the tension controller operates
correctly by turning it left and right.
E)
With the help of the Allen key, fit and
secure the main post (7) using the
Allen screws (19) and the corrugated
washers (20).
Figure 4
A)
Attach the left-hand pedal arm (16)
to the frame (1) using the flat washers
(18) and bolts (19) to secure it. Slide
the left-hand central handlebar (8)
onto the left-hand lower handlebar
(14) using the flat washers (22) and
bolts (22) to secure it.
B)
Attach the right-hand pedal arm (17)
to the frame (1) using the flat washers
(18) and bolts (19) to secure it. Slide
the right-hand central handlebar (9)
onto the right-hand lower handlebar
(15) using the fl at washers (22) and
bolts (22) to secure it.
Figure 5
A)
Connect the right (24R +25R) and
left (24L + 25L) pulse rate cables, and
then fi t the “U” type handlebar (10),
making sure not to catch any of the
cables. Secure the handlebar using
screws (23) and with the help of the
screwdriver ended spanner (37).
B)
Connect the top part of the monitor
cable (27) and the central part (28).
