BGU FSW 3.5 M, Оригинальное руководство пользователя

Страница: 11 / 32

11
Fit the rope into the special groove and tighten the screw (Pos. 8). Now start spooling as described
under pulling procedures.
In order to avoid possible rope damages keep winding up for a while after complete spooling of the
entire rope length, as described under section “Spooling of the wire rope”.
5.4.1 Unwinding the wire rope
After you have correctly installed the winch, you can start spooling the rope off. To accomplish suc-
cessful unwinding:
• Pull the red line (Pos. 2) till the Lever 1 snaps into the AUS position (Fig. 7).
• Release the brake and start spooling the wire rope off.
• If the wire rope is tangled or badly wounded on the drum, first unwind the entire rope length.
Keep running the tractor idle while loading the winch and completely rewinding the rope onto the
drum. Stop pulling as soon as the tractor reaches close to the anchor-point where the rope end was
attached.
• Now disengage the clutch lever.
Make sure that pulling is performed smoothly and without rush movements that could re-
sult into tangling, twirling or kinkling of the rope.
5.4.2 Checking the wire rope quality
• Stricly use brand new ropes.
• Make sure to use ropes of approved quality, suitable strength and compliant to the specifications
identification label.
• Do not use longer ropes than instructed in the technical specifications of this manual.
5.4.3 Winding up the wire rope
Completely spool the rope making sure to wind it tightly and evenly onto the drum and avoiding both
overwinding and underwinding.
Correct winding is accomplished by:
• Simply pulling of a load
• Firmly attaching one end of the cable to a stable anchor-point suitable to withstand the pull force
while the rope starts spooling onto the drum pulling tractor and winch towards the anchored rope end.
It may be convenient to carry out this operation either on a slight gradient with the idled tractor facing
uphill or alternatively with braked tractor.
Wind the rope tightly and evenly onto the drum. Before putting your winch to
work spool the rope off leaving only 3-4 winds on the drum and then rewind
it again! Check the rope over for any signs of damage, flattening, broken
wires, wear and corrosion.