BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
IMPORTANT NOTES ON PERSONAL SAFETY
•
Operate the tool using common sense.
•
Do not wear loose clothing or jewellery that can be caught by moving parts and cause serious
injury.
•
Only operate the tool at a safe distance from yourself and other persons
•
Always ensure a firm foothold in order to be able to maintain your balance at all times.
•
Never reach through or over electric cable or air hoses.
•
Always work with a second person present; in event of an accident, this person can call for help
or medical assistance.
•
Do not use this tool if you are under the influence of medication, alcohol or drugs, or if you are
tired. Read the package insert of your medicine in order to rule out an impairment of your
judgement or reflexes.
•
Do not use the device if there is any doubt about the functionality of this tool.
•
Always stay aware. During work, observe your workplace and carry out work with utmost care.
•
Before use, check the tool for damage. If a part is damaged, use the tool again only after all
damaged parts have been repaired by an authorised specialist.
OCCUPATIONAL SAFETY
Always wear suitable protective equipment when using pneumatic tools
.
Always wear
anti-slip safety shoes
,
work gloves
,
approved safety glasses a
nd
hearing protection
,
if
you are working with pneumatic tools
.
If you have long hair, always wear a hair net if you are working with pneumatic tools
that are equipped with motorised rotating or moving components
.
Always wear an approved dust mask if you are working with pneumatic tools where
dust can be stirred up or dust is produced
.
SYMBOLS
The symbols below are attached to the device / packaging and have the following meanings:
Air Inlet
Air Consumption
Max. Working Pressure
UNPACKING
When unpacking, make sure that all parts are present.
Contact your dealer if parts are missing or damaged
.
MAINTENANCE
•
Drain the compressed air system before each use. Water in the air lines leads to a loss of
performance and damage to the air tool.
•
Clean or replace the air filter on the compressor at the prescribed intervals.
•
Only operate the air tool with the maximum pressure specified in the chapter "Technical data".
