BGS technic 70971, Инструкция по эксплуатации

Страница: 7 / 20

SW-Stahl und Werkzeugvertriebs GmbH Tel. +49 (0) 2191 / 46438-0
F 5 6 e s s a r t S r e s u k r e v e L ax +49 (0) 2191 / 46438-40
e d . l h a t s w s @ o f n i : l i a M - E d i e h c s m e R 7 9 8 2 4 - D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
SAFETY WHILE OPERATING
Take enough time for a careful selection of a working area. Take care that your workplace is near to
the compressor and blasting material. Attention ! Always stay aware. Remove the device or other
objects from the working area. Persons and animals must not remain in the working area. Never
direct the air tool against persons or animals. Always wear safety equipment like safety glasses and
dust masks when working with this air tool (see chapter “Occupational Safety”).
AIR SOURCE
Clean air at the correct pressure is essential to supply this tool. The working pressure for this tool is
specified in chapter "Technical data" and is recommended for most compressed air tools of this class.
An increase in pressure is required if the length of the air hose or other circumstances result in a
decrease in pressure. The air pressure has to be increased in order to guarantee the working
pressure at running tool. Water in the hose and compressor leads to a reduction in performance and
damage to compressed air devices.
RECOMMENDED COMPRESSED AIR SYSTEM
No. Designation No. Designation
1 Air tool 6 Drainage/filtering unit
2 Air hose 7 Drainage valve
3 Quick coupling 8 Shut-off valve
4
Oiler
(for tools with motor)
9 Dryer/filter unit
5 Pressure reducer 10 Compressor
WARTUNG
• Air tools should be operated on air systems that have an automatic oiler.
When using air systems that do not have an automatic oiler, air tools
must be regularly added oil to the air tool via the air connection.
•
Before first use, add 4 to 5 drops of air device oil to the air connection of
the device.
•
Do not use engine or gear oil, to oil pneumatic tools; only use oil for
pneumatic tools.
• Drain the compressed air system before each use. Water in the air lines
leads to a loss of performance and damage to the air tool.
• Clean or replace the air filter on the compressor at the prescribed
intervals.
•
Only operate the air tool with the maximum pressure specified in the
chapter "Technical data".