BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
RECOMMENDED AIR SUPPLY
No.
Description
No.
Description
1
Air Tool
6
De-Watering / Filter Unit
2
Air Hose
7
Pressure Release Valve
3
Quick Coupler
8
Shut-Off Valve
4
Oiler (only required for air tools with motor)
9
Dryer / Filter Unit
5
Pressure Regulator
10
Compressor / 11 De-Watering Valve
OPERATION
Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil placed in
the
air inlet is sufficient.
Use proper air pressure and CFM rating listed for this tool.
1. To set the tool to desired torque, select a nut or screw of known tightness of the same size, thread
pitch and thread condition as those on the job.
2.
Turn air regulator to low position, apply wrench to nut and gradually increase power (turn regulator
to admit more air) until nut moves slightly in the direction it was originally set. The tool is now set
to duplicate that tightness
.
All bolts must always be checked with a torque wrench after
installation.
3.
Do not tighten nuts or screws with higher torque than allowed. Put nut or screw in the thread and
start attach several revolutions by hand. With the impact wrench tighten the screw until it rests
flush against the supporting surface.
LUBRICATION & MAINTENACE
Oil tool before each use. 4 to 5 drops Air Tool Oil placed in the air inlet is sufficient.
Use proper air pressure and CFM rating listed for this tool.
TROUBLESHOOTING (
I
nsufficient power)
Probable Cause
Solution
Dirty or clogged air passages
Flush and lubricate tool, drain air tank and supply line
Insufficient air supply
Increase line pressure, make sure compressor matches tool's
air pressure and consumption needs
Air leakage
Use teflon tape at all fittings and joints.
Check tool for worn or damaged o-rings & seals.
Worn/damaged wear & tear parts
Replace as necessary
Tool matching
Be sure you are using a tool suited for the sanding
requirements of the job at hand.
