SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
F
5
6
e
s
s
a
r
t
S
r
e
s
u
k
r
e
v
e
L
ax +49 (0) 2191 / 46438-40
e
d
.l
h
a
t
s
w
s
@
o
f
n
i
:l
i
a
M
-
E
d
i
e
h
c
s
m
e
R
7
9
8
2
4
-
D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
Art. 3229
Art. 3234
Art. 3239
Art. 3224
Reversible Air Ratchet
Please always follow the safety rules and instructions in this manual to avoid the risk of
personal injury and fire. It is absolutely necessary to study the operating manual before
starting this tool. Please keep these safety instructions.
1. Noise and 2. Vibration
Warning : Please always wear ear protector at environment noise level >85 dB(A) due to risk of
impaired hearing!
Noise characteristic values in accordance with EN15744: 2002
Vibration characteristic values in accordance with EN28662-1, EN ISO 8662-4
3. Foreword
This hand-held air ratchet wrench consist simply of a motor connected to the drive spindle through
reduction gearing. Torque delivered by the tool is adjusted by regulating the pressure of the air
entering the motor. The operator applies the tool to the fastener, starts the motor, and allows it to run
until the torque in the fastener builds up to the point where the motor stalls reaction. Which is a
perfect tool apply for tightening or loosing threaded fasteners which the work of body shop,
construction machine, light assembly in electrical, boat ... etc. Any other use is forbidden.
4. General safety rules
Read all these safety instructions before operating this product and save these instructions.
When using air ratchet wrench, basic safety precautions, including the following, should always be
followed to reduce the personal injury and fire. If you have any question, please contact our
authorized representatives. The manufacturer will not accept any responsibility for damage caused by
improper use of this tool.
4.1
For your own safety, read instruction manual before operating the tool.
Learn the tool’s application, and limitations as well as the specific hazards peculiar to it.
4.2
Danger of explosion!
Never use oxygen and combustible gas as an air supply for the tool which may be ignited by spark
and cause fire or explosion. Only use filtered, lubricated, regulated compressed air.
4.3
Never use gasoline or other flammable liquids to clean the tool.
Vapor in the tool will be ignited by spark and cause the tool to explode.
