BFT IANUS BT 300 KIT, Инструкция по установке и эксплуатации

Страница: 31 / 97

IANUS BT 300 KIT - IANUS BT 500 KIT
-
31
D812457 10550_02
C
C
d
PRELIMINARY CHECKS
Remember that the drive is designed to make the gate/door easier to use and will not solve problems as a result of defective or poorly performed
installation or lack of maintenance�
Check that:
- gate's running track is straight and horizontal and that the wheels are strong enough to take the weight of the gate: once released, the leaf
should be perfectly still and should not open or close;
- there is a slideway at the top of the leaf to avoid vertical or lateral oscillations during manoeuvres;
- leaf movement is even and there is no friction concentrated in any part of its travel;
- the existing structure has the necessary durability and stability requirements, specifically screws, bolts and rods that must be suitably secured;
- the leaf surface is free of protrusions and sharp edges, without signs of abnormal wear, rust, breaks or cracks in frame elements;
- there are mechanical stops secured to the ground in opening and closing;
- the stated temperature range is compatible with the site in which the automated system is due to be installed;
- any thresholds in the passageway and greater than 5mm are visible, indicated or well-formed�
If the frame and gate do not meet the indicated specifications, do not install the drive: have the frame adjusted as necessary by qualified personnel�
Important:
- Eliminate the gate lock or any other manual lock device�
- This product cannot be installed on leaves that incorporate doors�
- The pair of photocells supplied in the kit must be installed and tested at the end of installation�
- Make sure safety gaps < 8 mm in upper guides or apply rubber protections�
- If there are slots in the leaf or gate, install a protective mesh whose dimensions depend on the distance between the
leaf and gate, according to that indicated in the following table
STOPS
The gate can be stopped by stops secured to the floor so that travel is defined from opening to closing�
The distance between
the gate and leaf Mesh dimensions
≤ 120mm d ≤18�5mm
≤ 300mm 18�5mm < d ≤ 29mm
≤ 500mm 29mm < d ≤ 44mm
850mm d > 44mm
STOPS STOPS