BFT CSB Xtreme, Инструкция по установке и эксплуатации

Страница: 30 / 84

Control unit
EN
- 30 -
It is recommended to make an installation which has all the accessories necessary to ensure operation according to current provisions,
always using genuine devices.
This equipment must be installed and used in strict compliance with the manufacturer’s instructions. The manufacturer cannot be held
responsible for any damage deriving from improper or unreasonable use.
The constructor disclaims all liability for any inaccuracies contained in this booklet and reserves the right to make changes at any time
without any prior notice whatsoever.
This mode is used to copy the keys of a transmitter already stored in the receiver memory, without accessing
the receiver.
The fi rst transmitter is to be memorised in manual mode (see paragraph 10.4).
a) Press hidden key on the transmitter already memorised.
b) Press key T on the transmitter already memorised, which is also to be attributed to the new transmitter.
c) Within 10 s., press hidden key on the new transmitter to be memorised.
d) Press key T to be attributed to the new transmitter.
e) To memorise another transmitter, repeat the procedure from step (c) within a maximum time of 10
seconds, otherwise the receiver exits the programming mode.
f ) To copy another key, repeat from step (a), having waited for the receiver to exit the programming mode
(or after disconnecting the receiver from the power supply).
11.5 SELF-LEARNING MODE PROGRAMMING
Hidden key
12. WARNINGS
In case of standard installations where no advanced functions are required, it is possible to proceed to manual
storage of the transmitters, making reference to programming table A and to the example for basic programming.
1) If you wish the transmitter activate output 1, press pushbutton PR1, otherwise if you wish the
transmitter activate output 2, press pushbutton PR2.
2) When LED DL1 starts blinking, press hidden key on the transmitter, LED DL1 will remain continuously on.
3) Press the key of the transmitter to be memorized, LED DL1 will fl ash quickly to indicate that it has been
memorized successfully. Flashing as normal will then be resumed.
4) To memorize another transmitter, repeat steps 2) and 3).
5) To exit memorizing mode, wait for the LED to go off completely or press the key of a remote control that
has just been memorized.
IMPORTANT NOTE: ATTACH THE ADHESIVE KEY LABEL TO THE FIRST MEMORISED TRANSMITTER (MASTER).
In the case of manual programming, the fi rst transmitter assigns the key code to the receiver; this code is necessary
in order to carry out subsequent cloning of the radio transmitters.
11.4 MANUAL PROGRAMMING
11. RADIO RECEIVER
antenna cable RG58
11.1 RECEIVER TECHNICAL SPECIFICATIONS
- Max. n° of radio transmitters that can be memorized: 2 048
- Frequency: 433.92MHz
- Code by means of: Rolling-code algorithm
- N° of combinations: 4 billions
11.2 RADIO CHANNEL FUNCTIONALITY
Channel 1: Start command
Channel 2: Closes the relay contact on the terminal block J5 “CH2 RX”
10.3 ANTENNA INSTALLATION
Use an antenna tuned to 433MHz. Con-
nect the tuned antenna to the antenna
terminals using RG58 coaxial cable.
SHIELD
ANT
FC
C
J7
Hidden key
T2
T1
T3
T4
ENGLISH