10
9. Error Codes
Error Code
Issue
Cause
Solution
E0
Overcurrent error
(In Circuit)
Detected an overcurrent in the
circuit
Contact your dealer
E1
Overcurrent error.
(In Software)
Detected an overcurrent in the
software
Contact your dealer
E2
Retry Error
Motor was overloaded and
stopped and can not restart.
Contact your dealer
E3
ITRIP Error
Faulty motor or internal circuit
Contact your Dealer
E5
Overvoltage Input
Error
Overvoltage to the control box
Contact your dealer
E6
LED voltage error
Overvoltage in the internal cir
-
cuit.(more than 3.7V)
Contact your dealer
E8
Overheating error
High temperature safety system
activated due to extended use .
Wait for a while and
let it cool down before
using again.
8. Maintenance
If the O-Rings become worn, the motor might not connect
well to the hand piece, or water may leak. Replace the
O-Rings.
Changing the O-Ring
Remove the O-Ring at the motor insert with a pointed tool,
and mount the new O-rings into the groove.
Caution
There are 4 O-Rings on the Motor Insert. The blue one is thinner than the other 3. Make sure to
install them in the proper spot.
Caution
If the O-Rings become worn, it may cause:
- Air/Water leak
- Difficulty attaching/disconnecting the hand piece
- Excess Vibration
