FH07B Series Installation Instructions Issue 3.0
INS00306 Page 5 of 24
Introduction
General Description
Hazardous Areas
The Phoenix™ 7” FH07B Series Flameproof Camera Housing is certified to the EC (ATEX)
Directive 94/9/EC for use in hazardous areas.
A hazardous area is defined as an area in which explosive atmospheres are, or may be
expected to be, present in quantities such as to require special precautions for the
construction and use of electrical equipment. An explosive atmosphere consists of a mixture
of flammable substances with air in the form of gas, vapour, mist or dust in such proportions
that it can be exploded by excessive temperatures, arcs, sparks or flames.
Equipment is housed in an enclosure into which gas may gain access. Should this gas be
ignited within the enclosure, the resulting explosion will not reduce the pressure integrity of
the enclosure or will not be transmitted to any flammable atmosphere external to the
enclosure.
Note: This equipment may contain an ignition source even after disconnection.
Customer Orders
The FH07B Series of Flameproof Camera Housings are fitted with a customer (free issue)
supplied Camera and Lens and supplied with ATEX Equipment Certification by Bewator Ltd.,
at an additional cost. (Bewator Ltd. Part Number
FH07-CERT
). The Camera/Lens and the
installation MUST be compatible with the certification to the EC (ATEX) Directive 94/9/EC,
see Page 11. Bewator Ltd. can supply and fit suitable cameras and lenses on request.
The FH07B Series of housings can be supplied fitted with the following optional accessories:
FH07W
Wiper Unit Kit ~ 230Vac ~ 50/60Hz.
FH07W/L
Wiper Unit Kit ~ 24Vac ~ 50/60Hz.
FH07W/U
Wiper Unit Kit ~ 110Vac ~ 60Hz.
FH07-RX210
10 - function Receiver Kit ~ 110-230Vac.
FH07-RX217
17 - function Receiver Kit ~ 230Vac.
FH07-TKIT
Tamper Switch Kit.
To ensure compliance with the certification to the EC ‘ATEX’ Directive 94/9/EC, ANY of
these optional accessories MUST be pre-ordered and supplied factory fitted by Bewator Ltd.
The maximum combined power dissipation for all of the equipment fitted into the Camera
Housing MUST not exceed:
FH07B-40
Series
63W
FH07B-30
Series
50W
To ensure compliance with the EC (ATEX) Directive 94/9/EC, all orders that are placed for
Phoenix™ 7” FH07B Series Camera Housings MUST follow Bewator Ltd. Procedure
20G040, which includes the completion of a Phoenix™ Pre-Compliance Form by the
customer.
