FH07B Series Installation Instructions Issue 3.0
INS00306 Page 19 of 24
Figure 15 Fitting the Sunshield
2. Fitting the Sunshield.
a) Carefully place the Sunshield in
position on the Body, ensuring that
the front of the Sunshield is at the
front of the Body.
b) Fit the 4 off M5 nylon washers and
the 4 off M5 x 16 hex socket
button head screws. (See Figure
15.)
Locating The Unit
1. Please ensure that all equipment is suitable for the application and the environment for
which it is intended.
2. Please take particular care that the inter-connected equipment is fully compatible with
each other and is suitable for such use.
3. This equipment is to be installed out of reach of the user, or anyone who will come into
casual contact with the installation.
4. It is recommended that a prominent warning notice be affixed near to all moveable
Camera housing assemblies indicating that sudden unexpected movement of the
equipment may occur.
5. Be sure to provide suitable access equipment to ensure the safety of the installation or
the service personnel working on the equipment.
Mounting The Unit
1. The Camera Housing must be mounted properly and securely.
2. The Camera Housing can be mounted to a bracket, a column spacer, and a pan and tilt
(PTZ) unit or directly to a suitable structure.
3. Two sets of 4 x M6 screw mounting holes, equi-spaced on a 4” (101.6mm) p.c.d. (pitch
circle diameter), are provided on the base of the housing. It is recommended that the
rear set of 4 holes be used when cabling weighing greater than 5.0kg is connected to the
housing.
4. Note: When attaching to a pan and tilt unit, the Camera Housing MUST be bolted directly
to the mounting surface. The use of additional spacers is
NOT
recommended.
5. Note: The penetration of the 4 x M6 mounting screws into the housing mounting holes
MUST NOT
exceed 13mm. It is recommended that dimensional checks be performed to
determine the correct length of the M6 mounting screws to be used for the installation.
6. As the mounting surface to which this Camera Housing could be attached is site
dependent, Bewator Ltd. does not supply fixings for securing the base of the unit to its
mounting surface. It is the responsibility of installers to ensure that fixings are selected
that are fit for the specific purpose required.
7. An appropriate disconnection device MUST be included in the installation.
8. The Camera Housing may be subject to remote control and therefore may move at any
time. Persons working on the equipment should take appropriate precautions to ensure
that unexpected movement does not occur.
