43
SensEpil™ by beurer Setup
1. Remove SensEpil™ by beurer
BASE UNIT, APPLICATOR
and other components from box.
2. Verify that the
DISPOSABLE LAMP CARTRIDGE
is inserted correctly into the
APPLICATOR
.
3. Plug the power cord into the SensEpil™ by beurer
BASE UNIT
socket.
4. Plug the other end of the power cord into an electrical outlet. The
STAND BY INDICATOR LIGHT
will turn on.
Your SensEpil™ by beurer is now ready to start.
Treating with SensEpil™ by beurer for the fi rst time
The skin should be shaved, clean, dry and free of any powders, antiperspirants or deodorants.
5. Press the
POWER ON/STANDBY SWITCH
. The
POWER ON INDICATOR LIGHT
will turn on and a fan sound (similar to the
sound of a hairdryer) will start.
6. Approximately 4 seconds after pressing the
POWER ON/STANDBY SWITCH
, the
READY INDICATOR LIGHT
will turn on and
the device will beep. The device sets itself to deliver the lowest energy level pulses. The device is then ready
for you to trigger the fi rst pulse.
7. The energy level should be higher than the lowest, press the
ENERGY LEVEL SETTING BUTTONS
using the “-” or “+”
to respectively decrease or increase the energy level, until the desired energy level is set.
ENERGY LEVEL INDICATOR
LIGHTS
will coincide with the energy level setting. (See “Energy Level” frame).
8. Apply the
APPLICATOR
fi rmly to the skin, making sure the skin is spread evenly and smoothly. Make sure the
APPLICATOR TIP
is in full contact with the skin.
9. Press the
PULSE BUTTON
. The device will fi rst determine the color of your skin. If the color of the skin is light
enough for safe application, the device will fl ash a pulse of light onto your skin. You will see a bright fl ash of
light and simultaneously hear a subtle pop sound, which is a normal noise for the device. You may feel a mild
sensation of warmth and tingling. SensEpil™ by beurer will immediately recharge for the next pulse. After
3.5 seconds the
READY INDICATOR LIGHT
will turn on again and the device will beep.
10. Remove the
APPLICATOR TIP
from the treated area of skin.
11. Move the
APPLICATOR TIP
to another area of skin. Use the pressure marks the device just made on your skin
to guide you for proper positioning of the next pulse, avoiding both gaps and overlaps between pulses (See
“Covering skin areas” frame).
12. Repeat the process starting again with Step 5.
Quick Start