39
T
o replace a
DISPOSABLE LAMP CARTRIDGE
:
1. Press the
POWER ON/OFF SWITCH
to turn SensEpil™ by beurer off.
2. Unplug the power cord from the electrical outlet.
3. Grasp the used
DISPOSABLE LAMP CARTRIDGE
on both sides, pull it out of the socket and
discard with normal trash.
4. Unwrap a new
DISPOSABLE LAMP CARTRIDGE
.
5. Push the new
DISPOSABLE LAMP CARTRIDGE
gently into place.
If correctly installed, the
DISPOSABLE LAMP CARTRIDGE
will spring back when pushed in and
released.
Note: A DISPOSABLE LAMP CARTRIDGE should also be replaced if large spots appear inside it or if
its LENS is broken.
Do not attempt to open or repair your SensEpil™ by beurer device.
Opening SensEpil™ by beurer may expose you to dangerous electrical components and to pulsed light energy, either of which
may cause serious bodily damage and/or permanent eye injury.
Trying to open SensEpil™ by beurer may also damage the device and will void your warranty.
12.2. “A light pulse is not emitted when I press the
PULSE SWITCH
”
Make sure that you have good contact with the skin and that the
APPLICATOR TIP
is evenly and fi rmly pressed to the skin. For your
safety, the
PULSE BUTTON
will activate a pulse only if the
APPLICATOR TIP
is fi rmly pressed against the skin.
Check the
CONTROL PANEL
. If the
SKIN TONE WARNING INDICATOR LIGHT
blink for 3 seconds, this is an indication that your skin tone,
measured by the
SKIN
COLOR SENSOR
, is too dark for safe application. Try using the device on a different body part or contact
the SensEpil™ by beurer support.
Check the
REPLACE CARTRIDGE INDICATOR LIGHT
. If it is on, disconnect SensEpil™ by beurer and replace the
DISPOSABLE LAMP
CARTRIDGE
.
Make sure that the
READY INDICATOR
is on.
z
If within 10 seconds the
READY INDICATOR
remains off turn SensEpil™ by beurer off and back on by pressing the
POWER
ON/OFF SWITCH
twice.
Check the
SYSTEM WARNING INDICATOR LIGHT
.
If the light is on turn SensEpil™ by beurer off and back on by pressing the
POWER ON/OFF SWITCH
twice.
12. Troubleshooting
12.1. “My SensEpil™ by beurer does not start”
Make sure the power cord is properly connected to the SensEpil™ by beurer device.
Make sure the power cord is plugged into an electrical outlet on the wall.